Just want to be sure I understand how to do this correctly.
So, I'll need this switch:
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8833
Plug it in to the gear channel on my Rx. Then on the other end of the switch there are two wires. One I solder to any positive lead on my bottom plate. Then solder in the negative wire from the LED's to a negative lead on the bottom plate. Then the positive wire from the LED's gets soldered to the other wire on the turnigy switch.
That sound correct?
So, I'll need this switch:
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8833
Plug it in to the gear channel on my Rx. Then on the other end of the switch there are two wires. One I solder to any positive lead on my bottom plate. Then solder in the negative wire from the LED's to a negative lead on the bottom plate. Then the positive wire from the LED's gets soldered to the other wire on the turnigy switch.
That sound correct?