KDE Motor beeping

M

min0nim

Member
Hi guys,

My Hoverfly board has come in, and seems to be working well.

But now I'm arming it to test, all my motors are beeping and the ESC's aren't giving their arming tone. They're KDE 35 / 4012's.

When I plug the ESC's directly into the Rx, they arm correctly. But not when plugged into the Hoverfly.

I can see the throttle respond in the Hoverfly Setup client, so I don't think it's a simple wiring issue...

I can't find any info on what the motor beeps mean, but it might be that the ESC's aren't getting power or signal from the FC?

Any ideas?
 


M

min0nim

Member
Yes, I ended up using a DJI board.

I still have the HoverflyPro, but on a smaller copter.

There are a couple of threads on here where people offered suggestions. One that I didn't try was setting the Taranus offsets/end points. I'm on my phone now so it's harder to find, but I'll have a look when I'm home.

What is your setup - motors, ESC's, FC and Rx?
 


AzViper

AzViper

Active Member
Currently I get 6 quick beeps followed by a two tone beep beep on all motors. Then no more beeps, but cant start the motors.
 
Last edited by a moderator:

You must log in or register to reply here.
Top