Jerky Movements

[Ollie332]

Hello everybody, I am getting jerky movements every once in a while from my MK.
This is the first time flying it after I crashed it into a tree rather then the ground. Everything on the MK looks and feels fine and MK tools shows no errors. It flew pretty smooth before the crash so I have no idea on what could be causing this. Any suggestions are appreciate. Thank you!

 

[Crash]

Hello everybody, I am getting jerky movements every once in a while from my MK.
This is the first time flying it after I crashed it into a tree rather then the ground. Everything on the MK looks and feels fine and MK tools shows no errors. It flew pretty smooth before the crash so I have no idea on what could be causing this. Any suggestions are appreciate. Thank you!

Have you looked at the sensor readings in the MKTools scope?

 

[Ollie332]

Nope, where in MK tools would I find that at and what would the readings be if something was wrong? Thank you!

 

[BorisS]

ollie332,

check out my i am going to cry for a week thread on page three i go through alls the scope gyro testing stuff with videos of the scope

http://www.multirotorforums.com/showthread.php?753-Gonna-cry-for-a-week-!/page3

that should help you.

(edit) and thanks to crash i figured it out

 

[Ollie332]

Thank you!

 

[BorisS]

dont be distracted by my gyros doing such a wave link lines. They are doing that because the copter is swing back and forward on my balancing out construction. Normally having the kopter stand on the table they shouldn't be doing that.