I am trying to run the DJI iOSD on my WKM. I see the OSD screen on my monitor but it is not giving me and voltage, altitude nor does it give me the banking or up and down info when I hold the Hex and tilt it left, right, up or down. I am running old software and firmware. 1.20 and 5.02. Could this have anything to do with it. I do see the AV1 and the headers where you should see info from the WKM but no output from the WKM. I do have the cable connected between the iOSD and the WKM.
My Hex flies so good on 1.20 and 5.02 I didn't want to upgrade it unless it is necessary for the iOSD.
Thanks
Rich
My Hex flies so good on 1.20 and 5.02 I didn't want to upgrade it unless it is necessary for the iOSD.
Thanks
Rich
Last edited by a moderator: