iCharger Early Termination Problem

fabiolr

Member
Hello,

I bought a new iCharger 206B.

I charged a my Lipo’s a few times just fine.

Then a problem started happening with all my Lipos, so I think it is charger-related.

After 3 minutes into the charge, it terminates. It just says: Terminated xxx Mah 3m:01

The xxx of Mah it can put in the battery in 3 minutes depends on the current I use. I tried from 0.1 A to 5 A. Same issue.

It always stops at 3 minutes and 1 sec.

I have tried: Factory Reset. Connecting the charger to the car Battery, to eliminate a power supply suspicion.
I happens in Charge, Balance Charge, Fast Charge….

The battery is definitely not charged…. Cell voltages are 3.85 and they are set to 4.2 (I did a factory reset).

I don’t know what else to try… Has anyone seen this?

The charger is only 2 weeks old.. And returning is complicated now, I am abroad...

Please help!

Thanks
 

Attachments

  • icharger.jpg
    icharger.jpg
    119 KB · Views: 901

SoCal Blur

Member
Assuming that you have the correct battery type set up and the timer hasn't been set to 3 min, it sounds like a charger issue.
 

fabiolr

Member
Self-reply for the record.

I fixed this. It was a charger software issue. I downloaded the upgrade tool and the .bin from progressiveRC and was able to "upgrade" the software in it (I used the same version it was already in there, 3.14), but it served the purpose.
 


Top