How to setup retracts with Pixhawk and ER9X?

stu4371

New Member
Ok, noob question. I know I must be missing something easy here but would appreciate any suggestions to get this set up. I have a DJI 450 with a Pixhawk FC and a Turnigy 9x loaded with ER9X firmware. I just recently bought these retracts from HobbyKing and feel like I have tried everything to connect them properly.

My questions are, what output from my Pixhawk should I connect the retract to and how should I setup my transmitter? I'm using a X8R receiver connected from the SBUS output to the Pixhawk RC input. Thanks for the help, I feel like this should be super simple.
 

stu4371

New Member
I figured this out. Turns out I just needed to setup the X8R a little differently so it would recognize the servo outputs coming from the receiver as separate to the outputs from the Pixhawk. This thread and this blog were incredibly helpful in troubleshooting the desired config. Now I can use Channels 1-8 to fly and Channels 9-16 for other servos and switches.
 

Top