How to set timer to activate with throttle position on Graupner MX-20?

[Mactadpole]

I have tried several ways to program my Graupner MX-20 to start the timers when the throttle is beyond about the 15-20% position. I normally have one timer count up from 0 and the other count down from about 10-12 minutes so I know when its getting close to time to bring her home. I had no problem doing this on my Futaba but can't figure it out on this. I read on the MK wiki that using the available program setup will do this but I don't want to change everything. I just want to know how to do it.

Thanks for any help ya'll can provide! Shawn

 

[ghaynes]

Page 142 in the Manual. Pretty straight forward. One gotcha though is the resetting of the flight timer (stop watch/countdown is straight forward). Can't remember the steps but once the flight timer starts it keeps running even if you have powered down the quad.

 

[Mactadpole]

Well, 142 was it and p. 259 "Timer confirmation with control or switch" is too! Didn't realize they were called phase timers.


Thanks! Shawn