Hello everyone,
Today I maden my Y6 frame. The first flight did not go so well since I had the gain at 40, but it was 25 in my transmitter. I am now around 15 on the gains. It is almost good, but had a couple of question.
I am assuming this first issue is becuase I am using the same size props for both CW and CCW, but when I yaw to the right and then center the stick, the machine keeps yawing for another 10 deg, and if I punch out, it will yaw.
The next issue is that when I enable Autoleveling, the machine will lean forward and left a little causing the machine to fly away, so I have to hold the stick back, right to keep it level.
Then the third issue is when I enable Altitude hold, I have no more control over altitude.
Setup. F550 converted to Y6, 4s 4400 mAh batteries, RCTimer SimonK firmware ESC, DJI motors, DJI 8" props.
What are you guys using for props on a 4S setup in the Y6 config?
Thank You
Today I maden my Y6 frame. The first flight did not go so well since I had the gain at 40, but it was 25 in my transmitter. I am now around 15 on the gains. It is almost good, but had a couple of question.
I am assuming this first issue is becuase I am using the same size props for both CW and CCW, but when I yaw to the right and then center the stick, the machine keeps yawing for another 10 deg, and if I punch out, it will yaw.
The next issue is that when I enable Autoleveling, the machine will lean forward and left a little causing the machine to fly away, so I have to hold the stick back, right to keep it level.
Then the third issue is when I enable Altitude hold, I have no more control over altitude.
Setup. F550 converted to Y6, 4s 4400 mAh batteries, RCTimer SimonK firmware ESC, DJI motors, DJI 8" props.
What are you guys using for props on a 4S setup in the Y6 config?
Thank You