Guys
I am working on the roll and tilt axis at the moment. I figure out the correction movements and seem to work good on both tilt and roll. But problem is when the servo in neutral, it goes back and forth like the gain too high. I try lower the acceleration gain, correction become sluggish, yet the jitter on neutral still persist. At 4.8v there's no jitter on tilt, but have it on roll. At 6V, jitter are on both tilt and roll.
And other problem on the roll mostly, when camera is load on the mount, it seem like the board is not providing enough power, roll sometime stuck and can't move, but once tested with just the receiver, roll works just fine. And the Board sometime resets itself.
Also anyone can enlighten me on how to activate the pan axis? I can't seem to have the pan moving.
I modified my own pots with 5K 3 turn on tilt and 5k 5 turns on pan. They work just fine with just receiver, but jitter only happen when plugged into the Hoverfly gimbal.
I am working on the roll and tilt axis at the moment. I figure out the correction movements and seem to work good on both tilt and roll. But problem is when the servo in neutral, it goes back and forth like the gain too high. I try lower the acceleration gain, correction become sluggish, yet the jitter on neutral still persist. At 4.8v there's no jitter on tilt, but have it on roll. At 6V, jitter are on both tilt and roll.
And other problem on the roll mostly, when camera is load on the mount, it seem like the board is not providing enough power, roll sometime stuck and can't move, but once tested with just the receiver, roll works just fine. And the Board sometime resets itself.
Also anyone can enlighten me on how to activate the pan axis? I can't seem to have the pan moving.
I modified my own pots with 5K 3 turn on tilt and 5k 5 turns on pan. They work just fine with just receiver, but jitter only happen when plugged into the Hoverfly gimbal.
Last edited by a moderator: