henrysj
Member
Hi guys,
I've been an avid lurker on here for a few months now - and first off would like to thank you all for the time and effort you put into this forum, the information available is staggering and I wouldn't have got nearly as far without you all.
I'm in the process of of Skyjib X4 with Herk V3 build but cant decide where I should be taking the feed for my 26V to 12V BEC to power the LEDs.
The options I seem to have are:
A) Take a split from 1 Lipo before Herk board (As the Lipos are in parallel when they reach the herk board I dont think this would drain 1 lipo faster than the other but please correct me if I'm wrong?)
B) Take a split from both Lipos before Herk board (therefore definelty in parallel)
C) Take a split from the top of the Herk board from the red/black silicon wires leading to the FC (risk of overloading the 1.5amp max?)
Many thanks in advance for any help
I've been an avid lurker on here for a few months now - and first off would like to thank you all for the time and effort you put into this forum, the information available is staggering and I wouldn't have got nearly as far without you all.
I'm in the process of of Skyjib X4 with Herk V3 build but cant decide where I should be taking the feed for my 26V to 12V BEC to power the LEDs.
The options I seem to have are:
A) Take a split from 1 Lipo before Herk board (As the Lipos are in parallel when they reach the herk board I dont think this would drain 1 lipo faster than the other but please correct me if I'm wrong?)
B) Take a split from both Lipos before Herk board (therefore definelty in parallel)
C) Take a split from the top of the Herk board from the red/black silicon wires leading to the FC (risk of overloading the 1.5amp max?)
Many thanks in advance for any help