Here's a funky question...

SMP

SMP

Member
Changing props on the AD6 and decided check motor balance (Laserpointer etc) during which I reached out to lightly grab the motors (no props on kids) and behold two motors stopped spinning with significantly less resistance than the other four?!?

Does this mean:
A: ESC's are not giving the other two motors as much power and need to be reprogrammed?
B: Has nothing to do with ESCs
C: It's absolutely normal, move along, nothing to see here...
D: WTF are you doing grabbing spinning motors, with or without props?!?!

PS... Any resources on learning how to check/change ESC programming??
 


kloner

kloner

Aerial DP
if theres no symptom then def C..... they don't all power exactly the same, running on the ground makes the throttle shift all over the place without being visible......
 


kloner

kloner

Aerial DP
there isn' alot of playing with esc programing other than motor timing. That makes it run hotter than normal, or lesser than normal. usualy a motor likes one of them best. played with that alot in SRH's. The rest is basicaly disabled by lying to it so it won't LVC
 

You must log in or register to reply here.
Top