help on setting up a pixhawk

[epic4me]

Hi,
I have been using naza v2 and wookongs on my other quads with no problem; I have recently brought a Pixhawk, there are to few instructions in how to set it up, I have been trying using Mac and windows with no succes, using also APM2 AND MISSION PLANNER, AND NO SUCCES, mission planer says that is communicating to Mavlink ??? and nothings happens, I have followed the instructions on the booklet, and I cannot pass the pass 3 and cannot do the calibration,

also Futaba does not tuns on if connected on sbus, but if use inmmersion on the RC connection it goes on, the firmware is always loaded succesfully,
after that I can do nothing



Frustrating

Thanks
:upset::upset::upset::upset:

 

[R_Lefebvre]

Have you read through this wiki?

http://copter.ardupilot.com/

I'm having trouble understand exactly what problem you're having.

 

[TahoeTim]

wrong com port?

 

[epic4me]

The manual was wrong ( booklet)

http://youtu.be/_O0p8RY8_Lk

http://youtu.be/3uGdbkIJPj0


I have e mailed to 3dr no answer yet



Sent from my iPhone using Tapatalk

 

[dazzab]

The 3DR hardware support forum might be helpful. You will find it at http://ardupilot.com/forum/

 

[srbell]

Don't connect your sbus rx to sbus port on the Pixhawk. Sounds stupid but it was a mistake on the older documentation. It's a sbus output port, not an input. You have to plug into the rx in. Also, did you use the new wizard for your initial setup in Mission Planner? I'm in the process of tuning my pid's on a few Pixhawks if you have any more question. Like yourself, I've used DJI until now.

 

[epic4me]

Thanks


Sent from my iPhone using Tapatalk