Help !!!!!!!! Naza Quad problem

mellumman

New Member
I am desperately asking for help with my Naza Quad problem
I set up a Naza controller on a XAircraft X650 foldable frame with DJI 30 amp Esc's and RCTimer 3536-11 motors and 12x4.5 props
The problem is the quad starts off ok and goes into a hover and flys fairly well for about 1 min then it can either surge upwards approx 2-3 metres
in bursts or it will drop suddenly and almost crash before I can get it to climb again and in erratic surges
Has anyone has a similar problem that they found a solution for?
Desperate Mellumman
 


mellumman

New Member
Help !!!! Naza Quad problem

Thanks for your thoughts Tomstoy2 - I have thought of that myself but after any flight time the ESC's are cold to touch as well as the motors
I have also tried smaller props reducing the current draw and still the same problem

When it first happened on maiden flight I thought it might be my wireing harness so I rebuilt it with heavier wire but no luck
Originally I started the build with RCTimer 30 amp esc's - I thought it might be an incompatability problem so I replaced them with DJI 30 amp esc's but no luck

The funny part is, if I setup the quad with RCtimer 3536-11 motors - DJI 30 amp esc and 12x4.5 props and use a 3300 4s lipo the quad flies perfectly
If I change the lipo to a 5000 4 cell the surge problem appears if I change back to the 3300 problem goes away

It seems to be the extra weight of the 5000 pack creating the prob as I tied the 5000 pack onto the quad with the 3300 pack connected and the problem was there

At first with the 5000 4s lipo packs the problem would be there right from take off but after I increased the vertical gain to 200 I could at least fly for a short time before the prob appeared

I have flown for a short time in manual mode and haven't noticed the problem but tomorrow i'll try manual mode for a longer time and see what happens

When the problem first arrived a mate of mine came around with his standard Quad and we swaped Naza controllers and rx and tx but the erattic surges were still there

I sometimes wish I had built a standard rig but I need to lift an AUW of about 2500g so I went for bigger motors
 

Tomstoy2

Member
Do you only have one 5000 pack? If no, does it do this with the other 5000 pack? Could be a battery issue. Are you running voltage protection? If so, try it with it disabled.
 

mellumman

New Member
I have tried with 4 different 5000 packs and 2 different 3300 packs and the same problem
I have also tried turning off battery monitoring and still no luck
 

Top