Have i got this correct?

country kid

New Member
Hey guys, been reading for a while and its a great forum full of really good information, if being playing with RC for a while i have a HBKII helicopter and a Blade 400. Iv also had probably 5 foam planes over the years.

I would really like to get into the drones and have something middle of the line to carry a Gopro around n take some videos. i have a few questions i was hoping you could all help with.

1. in my head i have formulated a list of parts please tell me if this is correct or what input you may have:
-DJI F550 Flame wheel kit, using their propellers and motors ( DJI 2212-920kv motors) ([FONT=Source Sans Pro, Helvetica Neue, Helvetica, Arial, sans-serif]9 x 4.3" props)[/FONT]
[FONT=Source Sans Pro, Helvetica Neue, Helvetica, Arial, sans-serif]-DJI Naza V2 [/FONT]
[FONT=Source Sans Pro, Helvetica Neue, Helvetica, Arial, sans-serif]-Spectrum AR9020, which is a 9 channel receiver, i math 7 chanels for the platform and 2 for a gimbal? [/FONT]
[FONT=Source Sans Pro, Helvetica Neue, Helvetica, Arial, sans-serif]-Gimbal down the road along with FPV and OSD. (any recommendations?)

[/FONT]2. will my Spectrum DX6i be sufficient to run all of this?

Thanks guys, i look forward to the learning experience and your input.
 

country kid

New Member
Thanks for your response, so effectively i should look at getting an 8 channel or higher? as far as switching on Aux channels. is it possible to program say Aux3 to control the gimbal, so when you flick it over you can use one or the other sticks to control its orientation? iv seen it done, i would just asume 1 channel for each orientation.
 

PeteDee

Mr take no prisoners!
Yes, 4 channels for basic elevator, pitch and yaw plus throttle then one for flight mode, one for orientation control if you really want it then gimbal pitch, gimbal roll is usually not wanted and number 8 is spare for video switch if you want it. I only have video switching setup on my Disco Pro, have not bothered with others.

Pete
 

Top