Kilby
Active Member
Hey gang,
While waiting for some parts to show up to finish a new gimbal build on my big quad, I put an H3-3D on to have something to shoot with. I'm flying a Wookong hooked up with S-Bus to the pilots controller. Normally, I set up all our rigs as a two person operation, but this set up is a little confusing how I would do that. The input to control the pitch of the gimbal comes directly from the Wookong's S-Bus input. In the past, I have always ran a PWM line from the camera operators RX into our Alexmos controller. Since I'm using S-Bus on the Wookong, I don't see any way to route a signal from the second RX to the pitch control input (X3) on the Wookong. Does anyone know how to work around this? Can I simply run that same lead that I would normally into the Alexmos board into the X3 input on the Wookong? It seems that the WK is already assigning an input to that lead and I don't know what will happen if I send an outside signal to it.
Thanks,
Terry
While waiting for some parts to show up to finish a new gimbal build on my big quad, I put an H3-3D on to have something to shoot with. I'm flying a Wookong hooked up with S-Bus to the pilots controller. Normally, I set up all our rigs as a two person operation, but this set up is a little confusing how I would do that. The input to control the pitch of the gimbal comes directly from the Wookong's S-Bus input. In the past, I have always ran a PWM line from the camera operators RX into our Alexmos controller. Since I'm using S-Bus on the Wookong, I don't see any way to route a signal from the second RX to the pitch control input (X3) on the Wookong. Does anyone know how to work around this? Can I simply run that same lead that I would normally into the Alexmos board into the X3 input on the Wookong? It seems that the WK is already assigning an input to that lead and I don't know what will happen if I send an outside signal to it.
Thanks,
Terry