Hi guys
after a couple of months playing with a Phanton 2 Vision, I decided to build my own Hexa from scratch.
I relied a lot on reading on this forum to plan my build, very resourcefull.
Today was my maiden flight and everything worked well (after a few mishaps)
Here is my final build:
F550 Flywheel (hex)
Naza v2 + BTU + CanHub + iOSD
T-Motor 2216 900kv motors
T-Motor 30A ESCs
T-Motor 10x3.3 Carbon Fiber Props and T-Motor 9.3 Props (testing best config)
Zenmuse H3-2D Gimble
GoPro 3+ Black
400mv 5.8 Ghz Video tx
LCD Screen + Receiver + Batt all-in-one
Futaba T8J + Rx (s-bus)
MaxAmps 11000 Mah 3S LiPo and Venon 5000 Mah 4S LiPo (still testing best config)
Carbon Fiber Legs
I'm ready to start shooting some aerials from Sao Paulo.
Thank you all for all the content posted, see you around...
Fabio
after a couple of months playing with a Phanton 2 Vision, I decided to build my own Hexa from scratch.
I relied a lot on reading on this forum to plan my build, very resourcefull.
Today was my maiden flight and everything worked well (after a few mishaps)
Here is my final build:
F550 Flywheel (hex)
Naza v2 + BTU + CanHub + iOSD
T-Motor 2216 900kv motors
T-Motor 30A ESCs
T-Motor 10x3.3 Carbon Fiber Props and T-Motor 9.3 Props (testing best config)
Zenmuse H3-2D Gimble
GoPro 3+ Black
400mv 5.8 Ghz Video tx
LCD Screen + Receiver + Batt all-in-one
Futaba T8J + Rx (s-bus)
MaxAmps 11000 Mah 3S LiPo and Venon 5000 Mah 4S LiPo (still testing best config)
Carbon Fiber Legs
I'm ready to start shooting some aerials from Sao Paulo.
Thank you all for all the content posted, see you around...
Fabio