Graupner MZ-18 and Tarrot 680 with Naza V2

R

RemiWiik

New Member
Hi.
Someone here villing to help me out:tennis:
As you ses in the headline I have the Graupner MZ-18 and Tarrot 680 with Naza V2.
I´m a beginner in this, and I don´t know how to set up my radio to the Naza.
Which modell type? Heli, acro etc?
Someone here so has done this so can help me out a bit?
Sorry for my bad english, I´m from Norway:02.47-tranquillity:
Regards
Remi
 


Rotorfreek

Rotorfreek

Member
What radio have you got?
In general you will use aero mode.

If your receiver supports S-bus or PPM then you will just need one cable from your receiver to the x2 port of the Naza. If not you need to connect each channel with its own cable, as per the Channel outputs from your receiver.

To help any more we really need to know the exact receiver, what you want to set up switches to do.

Sent by my thumb, a trusty slave to my crazy mind. The above is the ramblings of a lunatic, and should be treated as such. Terms and conditions apply.
 

R

RemiWiik

New Member
I have a Graupner MZ-18 with normal receiver.

BUT..
I´m strugling here. The motors won`t fire up.
When I testing the motors in the Naza program, only motor 6 "ticle", it wont start. Motor 1-5 is dead.
When I connect the motors directly to the receiver, evereything runs perfect, but not via Naza.
Do you have a idea about what´s wrong here?
Regards
Remi
 

You must log in or register to reply here.
Top