Hello everyone. After flying a few months on my new setup I have decided to finally invest into a gimbal. But I'm having a hard time understanding how it is connected to my rig. The gimbal came with NO instructions. I have assembled 90% but this last bit has me stumped.
Equipment:
-S550 Custom Build (Mini S800)
-Naza v2
-FrSky Taranis
-DJI e300 Motors/ESC
-2 Axis Gimbal (From PhotoExpress) Flying Nex5
-Simple BGC Controller 2.2 Firmware
MAIN ISSUES:
-How exactly do I connect and load this controller to begin?
-What power source/connectors do I need?
-How do I balance the gimbal?
-The gimbal hangs LOW. Maybe 3inches off the ground. Is this safe?
Some of these questions may be answered once the gimbal is powered on. But currently I haven't figured out exactly what power source is needed. No instructions or manual has made the process frustrating, but I may have been overlooking these aspects. Thanks for any help I can get! Pics attached
Equipment:
-S550 Custom Build (Mini S800)
-Naza v2
-FrSky Taranis
-DJI e300 Motors/ESC
-2 Axis Gimbal (From PhotoExpress) Flying Nex5
-Simple BGC Controller 2.2 Firmware
MAIN ISSUES:
-How exactly do I connect and load this controller to begin?
-What power source/connectors do I need?
-How do I balance the gimbal?
-The gimbal hangs LOW. Maybe 3inches off the ground. Is this safe?
Some of these questions may be answered once the gimbal is powered on. But currently I haven't figured out exactly what power source is needed. No instructions or manual has made the process frustrating, but I may have been overlooking these aspects. Thanks for any help I can get! Pics attached