Tomstoy2
Member
Here's the set up.
X/A Hexa
WKM with 5.10
mt2216-900kv & mt30a esc's
GoPro Hero2
mc6500pro with DCS2600 digital servo's
Props and motors are all perfectly balanced.
First the pic's of the set up, (below)
As you can see, I just have the gimbal mounted on top of foam on the load rails, secured by rubber bands.'
I should recieve another 4 load rail mounts and grommets tomorrow. I was thinking of removing the foam and installing these in the foam's place, put some Zeal tape on top and place the gimbal mount on top of that, hoping to eliminate some of the shakes.
In assistant, travel on both pitch and roll are at max, no binding.
Pitch gain is set at 35 and roll at 65.
View attachment 5498View attachment 5499View attachment 5500
To keep the vid from overlapping the pic's I will upload in a moment.
X/A Hexa
WKM with 5.10
mt2216-900kv & mt30a esc's
GoPro Hero2
mc6500pro with DCS2600 digital servo's
Props and motors are all perfectly balanced.
First the pic's of the set up, (below)
As you can see, I just have the gimbal mounted on top of foam on the load rails, secured by rubber bands.'
I should recieve another 4 load rail mounts and grommets tomorrow. I was thinking of removing the foam and installing these in the foam's place, put some Zeal tape on top and place the gimbal mount on top of that, hoping to eliminate some of the shakes.
In assistant, travel on both pitch and roll are at max, no binding.
Pitch gain is set at 35 and roll at 65.
View attachment 5498View attachment 5499View attachment 5500
To keep the vid from overlapping the pic's I will upload in a moment.
Attachments
Last edited by a moderator: