I have Firmware ver. 140710 installed.
I'm using a Android-4.4 phone and I can connect to Gemini-M, I'm getting a voice that is a unknown langauge. How do I change that?
I have done the Compass Calibration .
How do you switch the Gemini-M into a Peer-to-Peer mode?
The flight mode is in set in "Backlanding"
The User Manual is so darn confusing, you don't know if they are talking about a RC radio transmitter or A Cell phone in operating the QuadCopter.
Is there anywhere on the Internet some plain English Instructions on how to get the Gemini-M to operate.
I have been all over Youtube and the Internet for some instuctions on how to get this thing to arm the motors.
You kind of get the feeling your the only one that has a Gemini autopilot, every thing is in Chinese and that is a language I'm not well verst in.
I know the motors and ESC's work, I ran them before plugging them into the Gemini-M Controller, I also disconnected the positive+ wires from the servo cables before plugging them into the Gemini-M .
I'm using a Android-4.4 phone and I can connect to Gemini-M, I'm getting a voice that is a unknown langauge. How do I change that?
I have done the Compass Calibration .
How do you switch the Gemini-M into a Peer-to-Peer mode?
The flight mode is in set in "Backlanding"
The User Manual is so darn confusing, you don't know if they are talking about a RC radio transmitter or A Cell phone in operating the QuadCopter.
Is there anywhere on the Internet some plain English Instructions on how to get the Gemini-M to operate.
I have been all over Youtube and the Internet for some instuctions on how to get this thing to arm the motors.
You kind of get the feeling your the only one that has a Gemini autopilot, every thing is in Chinese and that is a language I'm not well verst in.
I know the motors and ESC's work, I ran them before plugging them into the Gemini-M Controller, I also disconnected the positive+ wires from the servo cables before plugging them into the Gemini-M .