Futaba 14SG Question

Racer38

Member
Any Futaba Experts out there ??

Here is my dilemma. I am using a 14SG on my F-550 Hex with Naza V2. I have my FPV Camera and a GoPro on a Gimbal. I want to be able to switch between cameras so I added a SmartFPV switch. Now my issue, where do I plug the switch into the RX to be able to assign a switch. Channel 5 does the Tilt on the Gimbal, Channel 6 allows me to switch between GPS, Atti, Man modes, Channel 7 handles the IOC, Heading Lock, and Channel 8 has the SBus plugged in. Hopefully someone has some insight into this ..
Thanks in advance ! Craig
 

econfly

Member
Any Futaba Experts out there ??

Here is my dilemma. I am using a 14SG on my F-550 Hex with Naza V2. I have my FPV Camera and a GoPro on a Gimbal. I want to be able to switch between cameras so I added a SmartFPV switch. Now my issue, where do I plug the switch into the RX to be able to assign a switch. Channel 5 does the Tilt on the Gimbal, Channel 6 allows me to switch between GPS, Atti, Man modes, Channel 7 handles the IOC, Heading Lock, and Channel 8 has the SBus plugged in. Hopefully someone has some insight into this ..
Thanks in advance ! Craig

It depends on your receiver. If you are using the R7008SB, then put the receiver in mode "D" (see page 2 of the receiver manual for how to do this). Then channel 9 will be port 1 on the receiver, channel 10 is port 2, etc. At the same time, the single SBUS connection to the NAZA will allow it to pick up channels 1 through 7. You can use channel 9, for example, for your switch.

Alternatively, if you have a receiver with SBUS2 support, plug the NAZA into that SBUS2 port (which will free up port 8). Put the receiver into a mode that uses port 8 for an actual channel (and not SBUS). Then you can run port 8 / channel 8 to your switch.
 

Racer38

Member
Thanks for the Help, I plugged the Naza into SBUS2 and everything is working, placed the RX in Mode A so Channel 8 is suppose to work. I assigned a switch to Channel 8 Aux5 and it shows on the TX as the switch working but its not switching the camera, so I must have other issues with the switch.
 

PeteDee

Mr take no prisoners!
I am using the same setup on my TBS Discovery Pro and am using S-Bus2, I use channel 8 to switch between the video feeds and it works fine.

Pete
 

Top