Frsky

[paktazh]

hi guys is any one using FrSKY with Turnigy I tried to bind them there was red light in RX for a while but it disappear the TX got red light on but no light on rx at all is it dead ????????????????? I used 7.4 2c lip for RX/ does any one using FRSKY thanks

 

[kristiaj]

You ARE using a FRsky TX module? You can not bind Turnigy transmitter to a FRsky receiver without FRsky TX module...

 

[paktazh]

I got the FRsky module too
but the light does not turn on the RX when i try to bind the Module and the frsky RX

 

[kristiaj]

If there is noe light, either it's not getting correct power or the rx is dead. Are you sure you have not reversed the powerleads? Not sure what type of rx you have, but the D8R is good for 3.5 to 10V, so 7.4V should not have burned it.

 

[paktazh]

tried alot the let light does not come but when i connect servo the servo kind of jerk when it get connected that is the only movement i get from it may be it is half dead half alive lolol