View attachment 16332
After a positive experience with a Phantom V1, I am assembling a F550. This is where I am at: a series of DJI modules [NAZA-M V2, PMU, IOSD Mini, Zenmuse H3-2D Module & Gimbal , GPS] connected to each other by means of canbus cables.As I understand it, this will allow the modules to communicate. Also, the AVL58 is connected to the Zenmuse module by means of a cable that has 1.] a power plug and 2.] a video plug that fits into the Zenmuse Module. The PMU apart from having a canbus cable into the NAZA, also has a lead into X3 of the NAZA The system will be controlled by a Futaba 14sg and corresponding receiver [not in this picture]. I have not been able to find a schematic that would correspond to the assembly of the modules that I listed.
There is a lot of info available, so I spent considerable time going through videos and forum threads etc. Unfortunately, I am still confused about the function of the port on the IOSD mini that has a normal lead video in & out.
Since I am adverse to blue smoke, any comment that would set me on the right path would be appreciated.
Thanks and Regards,
Herman
There is a lot of info available, so I spent considerable time going through videos and forum threads etc. Unfortunately, I am still confused about the function of the port on the IOSD mini that has a normal lead video in & out.
Since I am adverse to blue smoke, any comment that would set me on the right path would be appreciated.
Thanks and Regards,
Herman
Attachments
Last edited by a moderator: