er9x and naze having problems

[tommygunn]

.
I have the naza with the gps and i just switch over from the dx7 to a turnigy er9x
i figure out how to set the 3 pos switch.

But testing it out today forward and backwards is smooth up and down is smooth BUT when i do left or right it is not smooth it is very over responsive. i know it not the naza on the dx7 it was smooth.. this is on gps mode and att mode.
I

i have it setup simple
ch1 100% ail
ch2 100% ele
ch3 100% thr
ch4 100% rudder

Ch 5 -39% max id0
+ 4% max id1
+ 69% max id2


Dji
setting
mounting
x -2
y 0
z - 10
auto pilot
basic gain pitch 120 roll 120 yaw 100 vert 140


att gain 140 140


Thanks

Tommy

 

[tommygunn]

what i meant by too responsive forward and back it it "slides" roll/ail it kinda flaps when i move left or right causing big movements.

 

[b0nafide]

Put your gains all at 100% and test it.

Is your question only about the smoothness?

 

[tommygunn]

sorry for the delay I updated the firmware on the er9x and it seem to fix the issue.

Thanks!