ironhorse99
New Member
I have a question about motor rotation. I've heard the prop nuts tighten by rotation so there's less likelihood of spinning off which makes sense however my motor blades IE-front left/right rear spin clockwise & are marked by an R and (I'm standing behind the unit) the other 2 are opposite with no mark. The nuts loosen in the same direction of rotation. Am I correct in my thinking that the motors are spinning backwards?? I've been flying it in my living room & its seems fine(front left motor is tight & spins up last & stops first) I'd reverse the motors but don't see where to do it in the stock transmitter setting. I'd like to connect the quad via usb but am not sure what software to load & at this point don't want to flash librepilot as I've only had it for a week or so. Any thoughts.