Dx9 & u channel problem

paul foster

New Member
Hi there I hope this is posted correctly as I'm new to this forum so please forgive me me if I have it wrong. The problem I am having is I can't get my u channel in naza v2 to operate my GPS ATT & manual modes using the ppm single wire option . I am using a new orange r615x ppm receiver & have connected to the naza software calibrated the TX & all is working fine A E R T but when I flick my 3 position switch there is no movement of the u channel slider all that moves is the X1 slider. I have my dx9 set up for naza using the traditional setup as per freemarlochip. I was hoping just to connect the 1 servo wire to the bind on the r615x the on x1 on the naza & it would be fine. All seems to work except the u channel for my flight modes can anybody please help me as I have been at this for days & really struggling to find an answer even on u tube. Thank u all very much for any help given Paul Foster
 

Top