flyingeyeafs
Member
Hello all on my skyjib8 heavy lift with axi4120/20 with 15/4 xoar wooden props when i take of in atti mode it yaws to the left slighty and stops. any idears anyone??? thanks
Thank you i will try can you put the rudder gain on a manual control knob a well?Could be a number of issues:
COG (Center of gravity) not correct in WKN
Gains need a little adjustment
Calibration of TX
Props, Motor ect
I would start with COG then gains as well as checking props-motors.
I had an issue with my F550 drifting a little and upped the gains solved it..
Plus just a plus give it a little time to settle in when priming up.
Only suggestions maybe someone else will tell different but this is where I would start
Hello all on my skyjib8 heavy lift with axi4120/20 with 15/4 xoar wooden props when i take of in atti mode it yaws to the left slighty and stops. any idears anyone??? thanks
Will be most likely the motors are not perfectly vertical .
Measure on a flat surface from the floor to the tip of one prop , then measure the other tip of the same prop.. measurements should be the same , this will ensure the sitting vertical.
Quadcopters
to be honest i havent tried it freaks me out that its not moving right and if it goes wrong my baby is in:upset:Taking off slowly leaves your machine in the ground effect which creates havoc with flight control. Does it still yaw left if you take off quickly then hover around 3 feet?
Hi everyone thanks for your help i have it in the air now with no yawing . all i have now, is the aircraft not sitting completley level, and the led stats flashing imu data lost as i go into the hover has any one got any idears on this? thanksTaking off slowly leaves your machine in the ground effect which creates havoc with flight control. Does it still yaw left if you take off quickly then hover around 3 feet?
Hi everyone thanks for your help i have it in the air now with no yawing . all i have now, is the aircraft not sitting completley level, and the led stats flashing imu data lost as i go into the hover has any one got any idears on this? thanks