hellafilming
New Member
Hi Guys,
I have a X8 on a cinestar 8 frame with T-motor 4014- 400kv mayatech 65 amp SC, and some foxtexh 16x5.4 CF props
I have a few gain and "twitch" (may be prop related) problems but the one that need attention first is the difference in flight characteristics between modes. In GPS and ATT it will hover and fly good, no yawing or sideways flight. When I fly in manual mod it yaws to the right rather fast. I can trim out on my futaba14sg some where around 52 and it will fly correct. If I leave the TX trimmed and fly in GPS and ATT mode the copter yaws to the left like it would in manual. Normally I have the same flight characteristics in all modes. Anybody have any experience with this? Thank You
I have a X8 on a cinestar 8 frame with T-motor 4014- 400kv mayatech 65 amp SC, and some foxtexh 16x5.4 CF props
I have a few gain and "twitch" (may be prop related) problems but the one that need attention first is the difference in flight characteristics between modes. In GPS and ATT it will hover and fly good, no yawing or sideways flight. When I fly in manual mod it yaws to the right rather fast. I can trim out on my futaba14sg some where around 52 and it will fly correct. If I leave the TX trimmed and fly in GPS and ATT mode the copter yaws to the left like it would in manual. Normally I have the same flight characteristics in all modes. Anybody have any experience with this? Thank You