DJI released the firmware v1.6 for Zenmuse H3-2D!

D

DJI Innovations

Member
What’s new?
Firmware
1. Support of the A2 Flight Control System. Please connect the H3-2D’s GCU module either directly to the port labeled CAN2, located on the A2 Controller unit or the CAN port, located on any modules which are already connected to the CAN2 port using a CAN-Bus cable. The firmware of the A2 Flight Control System should be upgraded to V2.0 or above.

2. Optimized the output protection of the motors, so the gimbal will not enter the protection mode during maneuvering flight and the motors still are safe from over burning.

Important:
1. Phantom users with the P330CB-H3-2D central board should upgrade their firmware using the latest NAZA-M assistant software. The “V1.4 Gimbal IMU” upgrade can be found on the “Upgrade” page.

2. Other users should upgrade the “main controller” to V1.6 and the “IMU” to V1.4 using the latest Zenmuse H3-2D assistant software. Both upgrades can be found on the “Upgrade” page.

*Please upgrade the flight control system (A2/Naza-M/Naza-M V2/WooKong-M) to the appropriate or latest firmware. For more information, please visit the DJI website!
 

R

rilot

Member
When is the promised remote start / stop functionality coming that you've had listed on your website for 8 months?
 

I

iscorama

Member
Still can't upgrade firmware on the gimbal using P330CB-H3-2D and latest NAZA-M assistant software... so your 1st option is total bullsh*t. Expected from DJI.
 

J

Jel

Member
rilot said:
When is the promised remote start / stop functionality coming that you've had listed on your website for 8 months?
Click to expand...

+1

From the DJI website "The H3-2D gimbal is designed for the GoPro Hero3, and remote start/stop shooting, video transmission (video downlink required), etc of the GoPro Hero3 will be supported by future firmware upgrades."
 
Last edited by a moderator:

You must log in or register to reply here.
Top