Hi All,
This is my first post no this site so here go's. I've been flying my multicopter with dji naza board and upgraded gps for a couple months with no problem and work perfect. I went down to the field yesterday took off put it into atti mode and was fine THEN i put into gps mode and it was drifting everywhere and would't hold. So i tried fail safe to return home and multicopter fell out of the sky(good job a was high) so i put it back to manual mode and landed it and went home. When i connected it to the laptop it was showing no gps. So i went to a friend who as the same setup and tried my gps on his board and work perfect and then we tried my naza board with his gps and nothing so i put it down to the board. As anyone had this problem with there's or if you know how to fix it would be great. I have put the latest firmware and calibrate the compass but nothing seem's to work.
Thanks
lufc1976
This is my first post no this site so here go's. I've been flying my multicopter with dji naza board and upgraded gps for a couple months with no problem and work perfect. I went down to the field yesterday took off put it into atti mode and was fine THEN i put into gps mode and it was drifting everywhere and would't hold. So i tried fail safe to return home and multicopter fell out of the sky(good job a was high) so i put it back to manual mode and landed it and went home. When i connected it to the laptop it was showing no gps. So i went to a friend who as the same setup and tried my gps on his board and work perfect and then we tried my naza board with his gps and nothing so i put it down to the board. As anyone had this problem with there's or if you know how to fix it would be great. I have put the latest firmware and calibrate the compass but nothing seem's to work.
Thanks
lufc1976