DJI iOSD with Immersion TX Wiring Advice

[VINHEX]

I've just got the DJI OSD (Wahooo) Anyone got a diagram to show wiring on Immersion TX.. I'm using the balance lead as the FPV kit has a filter on it.. Any help would be appreciated.

Vin :nevreness:

 

[VINHEX]

Just looking at wiring but not sure the best solution. Camera requires 5v but unit pushes out 12 to feed camera on 3S. Any Advice would be appreciated. Thanks

View attachment 7407View attachment 7408

 

[ChrisViperM]

Can't help you with the wiring, but your 5V for the Camera you can get with this:

http://www.wiredrc.com.au/shop/speed-controllers/castle-cc-bec.html

Thats the one I am using...but there is a lot more similar products on the market....just Google for 5V BEC (Battery Eliminating Circuit, also called Step-Down regulator). There is another one: http://www.pololu.com/catalog/product/2177


Chris

 

[VINHEX]

Thanks Chris,
Diffidently a good start..

 

[VINHEX]

If I used the existing connections and only split to Video feed would this work? Still connect the power of the OSD as described in the diagram (DJI)
View attachment 7410

 

[VINHEX]

All sorted and up and running.. Weather not permitting to fly.... Arhhhhhhh


Vin
DJI F550
DJI WKM
DJI DataLink 2.4Ghz
3s 3300
3s 5000
Aeroxcraft Landing Gear
Graupner 10x5 e-Props
Spektrum DX8
AR8000 Receiver
TM1000
Fatshark Attitude SD
Sony Exview Had II CCD 650 Line Sony Effio-E
Fatshark Spironet Antenna's
DJI iOSD