DJI iOSD mark 2 "switching to data mode"

[Atomic Image]

Hi all,

I have the USB cable connected to my iOSD mk2, I can change the parameters with the software and I see the video overlay on the video signal. Everything is fine with that part.

Problem is when I try to switch the data mode, I want to access the files and the software is stuck with "switching to data mode" message... I hear no sound of a connect / disconnect device. I see the driver in the device manager and everything looks good. I tried many power cycles, running the software as admin, running the software before connecting the usb cable but now I don't know what else I could try.

Running A2 v2.2, Z15-GH3 and all latests softwares, I remember that it worked when I was running A2 v2.1 firmware... not sure if that matters. Running Windows 8.1.

Any tips?

Thanks

 

[Atomic Image]

For the record, the problem was the microsd card within the iOSD which became corrupted. I am putting a new one in there and it should be OK.

 

[soler]

I had the same problem, a bit tough to get out the SD with all that glue

 

[Atomic Image]

Yes!

Just installed a new sd card and it fixed all my problems.

Thanks