Guys, Hope you can suggest something to try here.
I have just installed an H3 2D DJI gimble to my phantom 2. I have installed it as per instructions. On power up the gimble along with the attached Hero3+ straightens up and faces forward. I can't however tilt the gimble either by the leaver at the back of the transmitter or a small screwdriver pushed the the hole also at the back of the transmitter.
I have upgraded the Gimbles IMU to the latest 1.8 and switched on the gimble in the software wizard.
Any suggestions would be greatly appreciated.
I have just installed an H3 2D DJI gimble to my phantom 2. I have installed it as per instructions. On power up the gimble along with the attached Hero3+ straightens up and faces forward. I can't however tilt the gimble either by the leaver at the back of the transmitter or a small screwdriver pushed the the hole also at the back of the transmitter.
I have upgraded the Gimbles IMU to the latest 1.8 and switched on the gimble in the software wizard.
Any suggestions would be greatly appreciated.