View attachment 24280 View attachment 24281 View attachment 24282 View attachment 24283 View attachment 24284 View attachment 24285 View attachment 24286 View attachment 24287 View attachment 24288 View attachment 24289 View attachment 24290 View attachment 24291 View attachment 24292 View attachment 24293 View attachment 24294 View attachment 24295
New assembled DJI F550 (never flown) and a new Spektrum DX9 radio...The radio was programmed to the NAZA v2 and the firmware was also updated to the newest version. The 550 comes with two new spare plates upper and lower pre soldered with power cable, six new spare arms,original landing gears, two extra props, and everything listed bellow.
FlySight 5.8GHz 32-Channel A/V Transmitter
1200mW (31dBm, +/- 1dB) of clean output power
SMA Antenna connector, with supplied 5.8GHz antenna.
Frequencies: 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
Fully compatible with 2.4GHz R/C radios
On-board quiet fan build-in
Boscam RC805 5.8G Hz Wireless AV Receiver
Receiving frequency:5725-5865MHz;8CH
Receiving sensitivity:-90dBm
Frequency control: built-in frequency and phase lock loop
Double lines AV output: analog AV signal output
Antenna connector: SMA(Inside the needle)
Power supply voltage: 5-12V
Supply current: 150mA
Dimension:75*54*15mm
Gross weight: 130g
ImmersionRC
Circular Polarized dome antennas
FPV landing gear
DJI V2 Naza flight control
DJI OSDmini
DJI CAN BUS
DJI Naza BTU Bluetooth Module
Spektrum DX9 Transmitter new in box with all accessories(some decals were used on the copter)
Spektrum AR8000 8 channel DSMX receiver
Custom LED
All you need are batteries and your ready to fly. This was a weekend project for me but just don't have time to continue. I'm asking 1,400 or best offer.
New assembled DJI F550 (never flown) and a new Spektrum DX9 radio...The radio was programmed to the NAZA v2 and the firmware was also updated to the newest version. The 550 comes with two new spare plates upper and lower pre soldered with power cable, six new spare arms,original landing gears, two extra props, and everything listed bellow.
FlySight 5.8GHz 32-Channel A/V Transmitter
1200mW (31dBm, +/- 1dB) of clean output power
SMA Antenna connector, with supplied 5.8GHz antenna.
Frequencies: 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
Fully compatible with 2.4GHz R/C radios
On-board quiet fan build-in
Boscam RC805 5.8G Hz Wireless AV Receiver
Receiving frequency:5725-5865MHz;8CH
Receiving sensitivity:-90dBm
Frequency control: built-in frequency and phase lock loop
Double lines AV output: analog AV signal output
Antenna connector: SMA(Inside the needle)
Power supply voltage: 5-12V
Supply current: 150mA
Dimension:75*54*15mm
Gross weight: 130g
ImmersionRC
Circular Polarized dome antennas
FPV landing gear
DJI V2 Naza flight control
DJI OSDmini
DJI CAN BUS
DJI Naza BTU Bluetooth Module
Spektrum DX9 Transmitter new in box with all accessories(some decals were used on the copter)
Spektrum AR8000 8 channel DSMX receiver
Custom LED
All you need are batteries and your ready to fly. This was a weekend project for me but just don't have time to continue. I'm asking 1,400 or best offer.
Last edited by a moderator: