johannes
New Member
Hi there
I am using DJI 5.8G Remote Controller and receiver for gimbal control and I am using one of the two bus ports on the reciver to control the gimbal.
is it possible to use both ports at the same time so there I can control an other device with s.bus or D.bus?
Also can someone tell me the output maping of channesl on the reciver?
Best regards
Johannes
I am using DJI 5.8G Remote Controller and receiver for gimbal control and I am using one of the two bus ports on the reciver to control the gimbal.
is it possible to use both ports at the same time so there I can control an other device with s.bus or D.bus?
Also can someone tell me the output maping of channesl on the reciver?
Best regards
Johannes