Welcome To DroneVibes

DroneVibes is a COMMUNITY of drones enthusiasts. We are experts at drones for all professional and consumer applications. We welcome you to register and join the conversation.

Custom Drone need help

Discussion in 'Drone Builds and Kits' started by Onen-MW, Jan 9, 2019.

  1. Onen-MW

    Onen-MW New Member

    1
    0
    1
    Jan 9, 2019
    Malawi
    Posted by Onen-MW, Jan 9, 2019 #1
    Hi i have built a 8 prop octo copter and its 1.1m wide, i am using radiolink at10 but am facing a few problems. is there any one that can guide me. i am using pixhawk with missionplanner. the first thing is that made mods to the remote. i added the spring and would like to us the handle set the limit. example if i take the throttle up from the middle it should take a lift up and then when i leave the handle it should stay the same place unless i push the lever down to reduce the throttle instead it works bonkers. the minute i arm it the props go in action. it show they at 50 percent.
    any ideas on that.
     
Loading...

Share This Page

Loading...