For Sale CarbonCore Cortex X8 fully loaded and 100% RTF! FREE SHIPPING IN USA!

charleshidalgo

I do things with stuff!
This amazing rig flies great and is rock solid. The gimbal could use a little more tuning (my opinion) but that will be up to the buyer. If it does not sell I will keep it and finish the fine tuning of the gimbal. This has flown and hovered for 20 minutes at a time with a full load for testing by me and has just around 3 hours total on everything except the camera and lens which only has about an hour on them . The gimbal attaches and is removed in a minute with four quick connect screws and two plugs for power and video. The Opale parachute is something I defiantly wanted on this big rig and is worth the price as far as I'm concerned. This rig out of the case and in the air sets up in a few minutes. The retractable landing work flawlessly. This is an amazing HD setup and the GH4 with it's DCI 4K 4096x2160 at 24p, and UHD 4K 3840x2160 at 30p/24p capabilities it was a no brainier. I feel this is the ultimate (for the price) in a heavy lift being compact (as far as these x8's are concerned) and quick to setup. It's configured to fly with a single operator but can be made a dual setup with simply adding another radio for the seconded person or go right back to a single immediately. This is 100% ready to fly on arrival (though you will need to review all settings, learn the controls, and do a IMU and compass calibration).

I always support my sales after as much as possible (check my feedback) but all sales are final. I had to learn 99% of this hobby on my own with years of trial and error and hours of reading and bench testing and with technology changing daily a certain level of know how is required to operate these multirotors and I'm not responsible for what the buyer does on their end once the receive these items. I do promise things will show up as described.

The build component list:
CarbonCore Cortex X8 frame
8 T-Motor MN 4010-14 370kv
T-Motor carbon props v2 4x 15X5, 4x 16x5
8 Maytech 50A esc's
WOOKONG M with bluetooth, GPS V2 , IMU V2 (the new aluminum style case)
2x 5.8GZhz Video TX's (one for main camera and one for FPV cam )
1 fatshark FPV camera (with tilt control and OSD )
1 OPALE rescue parachute
IFLight bet wiew GIMBAL for GH4 (with zoom and focus option , spectrum RX for gimbal control
Carboncore retractable landing gear
High amp power board , 5v bec ,12 v bec
Dji mini iOSD
4x 8000mah turnigy nanotech batteries (brand new)
Taranis plus radio tx with X8R rx for main controls and Spektrum module for gimbal control (all programmed for a single operated setup) full Yaw, Roll, Pitch, stop/start video, and shutter/photo control.
Liliput HD monitor with custom bracket for the Taranis
Like new (less than an hours use) Panasonic GH4 camera (with spare battery)
New Olympus 12mm in all black option

100% ready to fly.

5,000.00 net to me and I will ship and insure it anywhere in the lower 48 USA for free. I have shipped to many foreign countries as well but that would not be free. Paypal verified buyers only please. That or good old cash and local pickup works as well. This is cheaper than new if you price things out and then add the hours of labor to build it and you can see how things add up. Just the motors, esc's, and props are over 1,300.00, the camera and lens are around 1,800.00, the gimbal is 2,000.00, batteries were 400.00, and on and on.
IMG_2975.JPG
IMG_1673 (1).jpeg
IMG_2852.JPG
IMG_2848.JPG
IMG_2820 (1).JPG
IMG_2821.JPG
 

Attachments

  • IMG_2975.JPG
    IMG_2975.JPG
    431.4 KB · Views: 1,003
  • IMG_1673 (1).jpeg
    IMG_1673 (1).jpeg
    95.5 KB · Views: 1,037
  • IMG_2852.JPG
    IMG_2852.JPG
    411.2 KB · Views: 1,183
  • IMG_2848.JPG
    IMG_2848.JPG
    537.8 KB · Views: 1,216
  • IMG_2820 (1).JPG
    IMG_2820 (1).JPG
    509.5 KB · Views: 1,207
  • IMG_2821.JPG
    IMG_2821.JPG
    465.9 KB · Views: 1,221
  • IMG_2820.JPG
    IMG_2820.JPG
    509.5 KB · Views: 470
Last edited:




Top