CarbonCore 950 with Wookong plus Cinestar 3 axis gimbal, batteries, and transmitters-only $3.1k

quadbros

Member
Please pm us with an offer if you are interested, I am sure we can make a deal!

$3100 OBO

Selling because we simply don't use it enough!

Buyer will pay shipping! Shipping from Houston, TX.



So now for the good stuff, we have a full carbon fiber Carboncore 950 hexacopter. We bought this and have done some video but for now we aren't doing enough aerial video for it to be worth it to us to keep it. So as usual, our loss is your gain!!

Full Disclosure: this has been through one crash, it was an issue where we hadn't fully tightened a prop so it flew off and led to a crash. This was quite a while ago and we were just flying with some friends over an empty field. The crash was about 15 feet in the air and honestly the frame handled amazingly! The only damage there was, was some broken props and the holes where one of the arms was screwed in became a little larger so there was a small issue. When you are flying a $6000 hexacopter with a $2000 camera though you don't want to take any risks so we bought a totally new arm which has already been installed and replaced. Since then we have tested the motors and everything works flawlessly still.

So what this bad body comes with:
CarbonCore 950mm Hexacopter
Wookong-M Flight Controller
6-Turnigy Plush 40a ESC's
6-Rc Tiger Motors MT3515-15 Motors
2-Power Distribution Boards
6-Graupner 13" Propellers ( will include a couple extras)
6-Graupner Spacers
Devo 10 Tx and rx
LED lights
Various extras

This hexacopter was built proffesionally by Tony at RC-drones.com, this is where you would buy it new : http://www.rc-drones.com/CarbonCore-...ter_p_399.html

So that is $3100 for just the hex itself not even including the transmitter. Then there is also the gimbal which comes with :
Cinestar 3 axis gimbal with radian stabilizers
Graupner MX-12 tx and rx for a 2 man aerial video setup

The hex runs on dual 6s batteries and the gimbal operates on a separate battery ( We were using 3s) .

We will even include 2 5000mah 6s lipos to make this thing 100% charge your batteries and fly!

The wookong and cinestar usb programming cables will be included.

We flew a canon t3i on this with ease and got 10 minute flight times with the dual 5000 mah batteries. On the setup with the batteries as is you could increase payload a lot and you also could upgrade the propellors and batteries if you want longer flight times and higher payload.

Let us know if you have any questions, want more pictures, and of course PM us if you have an offer!

We can sell with or without transmitters and receivers plus batteries!

Also will accept partial trades for up to $500 of it!
 

Attachments

  • IMG_1818.JPG
    IMG_1818.JPG
    154.9 KB · Views: 352
  • IMG_1816.JPG
    IMG_1816.JPG
    128.6 KB · Views: 376
  • IMG_1819.JPG
    IMG_1819.JPG
    83.8 KB · Views: 726

Top