Bartman
Welcome to MultiRotorForums.com!!
Time for a little camera mount sleuthing, if you don't mind.
I'm trying to get my new mount dialed in but when I roll it left or right, as I stop moving it the camera mount gives just a little extra compensation and goes out of level. If I roll the heli to the right, just as I stop adding roll the mount kicks in a bit of extra and out of level it goes.
Has anyone dealt with this before? I've adjusted the roll compensation values above and below optimum but it still does it. In looking at the firmware revision notes it doesn't look as if any of them address gimbal control so I might as well stay at .82.
Thanks,
Bart
I'm trying to get my new mount dialed in but when I roll it left or right, as I stop moving it the camera mount gives just a little extra compensation and goes out of level. If I roll the heli to the right, just as I stop adding roll the mount kicks in a bit of extra and out of level it goes.
Has anyone dealt with this before? I've adjusted the roll compensation values above and below optimum but it still does it. In looking at the firmware revision notes it doesn't look as if any of them address gimbal control so I might as well stay at .82.
Thanks,
Bart