Building a hexcopter with DJI WKM tiger ESC and Tiger motor

paktazh

Member
Hi everyone I am trying to build a a hexcopter with DJI WKM tiger ESC and Tiger motor i already assembled the frame but need help regarding the wiring and the ESC wiring and how to use two batteries with them at once your help greatly appreciated
 

paktazh

Member
I figured out the wires but I am kind of confused about the the wires that goes to my Futaba 14 channel receiver it is unlike the Xaircraft that all 8 wires go to the receiver from the Xaircraft but in the Dji it only give you 5 ( A /E/T R/u )wires that goes to the receiver and the rest does not have any wire connection unlike Xaircraft to control the Gimbal ? if not connected to the receiver how do u control the gimbal
thanks in advance


Do I need to buy Futaba S-sub to be able to do that ?
 

Hi

You don't need an F-Sbus though it is easier as you only connect one wire for the Sbus. Goto page 16 of the manual and details on connections for non-Sbus Rx are illustrated, AETR to channel1/2/3/4 and u(control mode sw) to channel 7, X2&X3 rotary sw to channel 5/6. Your Tx channel for 5/6/7 should be programmed accordingly.

Cheers
 
Last edited by a moderator:

Top