RotorJockey
Member
Still quite new at R/C, but with some experience in mechanical devices (I'm actually electronics technologist). My buddy at the hobby shop gave me two used and reject bldc motors - one with a 'bent' shaft; the other with a seized top bearing.
I opened the 'bent' one first, and using a indicator gauge in a metal lathe, found that the relationship between the magnet cup and the shaft was not paralell by some 50 thou. Tapping the shaft while holding the cup in the chuck straightened this out by alignment of the shaft in the back-plate of the cup - not by straightening the shaft. Was this going to hold? So I made a circular punch and re-seated the shaft in the back-plate. It took a few iterations, but is now about 7 thou out, and works perfectly.
The other motor had heat dicolouration on the shaft and the 3mm x 7mm x 4mm bearing was partially frozen. Used an old 2mm shaft to remove the bearings, one at a time. They were easy to replace using a 3mm drill shank for alignment, and a hollow punch to press on the outside shell only during re-seating.
I would not really trust these motors for serious work until some level of confidence is built up, but much better than throwing them away!
I opened the 'bent' one first, and using a indicator gauge in a metal lathe, found that the relationship between the magnet cup and the shaft was not paralell by some 50 thou. Tapping the shaft while holding the cup in the chuck straightened this out by alignment of the shaft in the back-plate of the cup - not by straightening the shaft. Was this going to hold? So I made a circular punch and re-seated the shaft in the back-plate. It took a few iterations, but is now about 7 thou out, and works perfectly.
The other motor had heat dicolouration on the shaft and the 3mm x 7mm x 4mm bearing was partially frozen. Used an old 2mm shaft to remove the bearings, one at a time. They were easy to replace using a 3mm drill shank for alignment, and a hollow punch to press on the outside shell only during re-seating.
I would not really trust these motors for serious work until some level of confidence is built up, but much better than throwing them away!