XAircraft Assigning AUX2 channel to switch pilot lamp on..

Please ignore my previous post, I've since done a lot of reading.. (this hobby is so hard for a beginner)

Anyway. I have my AUX 2 switch on my JR remote set to the AUX 2 channel

Currently, there is no cable going from AUX2 on the receiver end to the FC 1212-P. I'm assuming this must be connected right??

Now how do I get this AUX2 channel to switch stuff on and off?? I want to assign this AUX2 Switch to 'talk' to my flight controller?

When flicking the AUX2 switch on my remote I want to 'assign' it to #7 as shown here:

http://www.playtimevideo.com.au/aux input.jpg

This is driving me nuts :(


-Frankie
 

Top