ActionDrone
Member
WWW.ACTIONDRONEUSA.COM
The AD1 simplifies the choice for people looking to carry a GoPro 3 on a Quadcopter. We have put the built in gimbal to create a vibration free video! We know that many of you now will travel with your Quadcopter as part of your GoPro 3 platform so we have made this frame a folding frame. Below is the sample video made during its made during its maiden flight.
Specification:
Airframe + Full Gimbal System(motor x2 + control board + IMU)
Frame Opened: length: 435mm,wide: 530mm,height: 105mm
After Folded (without props): length: 510mm,wide: 185mm,height: 105mm
After Folded (with props): 590mm,wide:185mm,height:105mm
The AD1 simplifies the choice for people looking to carry a GoPro 3 on a Quadcopter. We have put the built in gimbal to create a vibration free video! We know that many of you now will travel with your Quadcopter as part of your GoPro 3 platform so we have made this frame a folding frame. Below is the sample video made during its made during its maiden flight.
Specification:
Airframe + Full Gimbal System(motor x2 + control board + IMU)
- Airframe made out of 1.5mm board.
- 16mm round tubes x4
- 16mm round tube clamps & motor mounts,
- 2 axis brushless gimbal in the front designed for Gopro 3 only. (come with 2 brushless motors, control board & IMU installed)
- Gimbal motor GM2208-80 x2,
- Top transparency protection cover made out of 1mm bullet proof material,
- Front Lens cover made out of 1mm bulet proof material,
- Motor to motor 590mm (CG still in the x center, same as standard quadcopter),
- Total Flying weight about 1830g (included GoPro, GPS & 4S 5000mah)
Frame Opened: length: 435mm,wide: 530mm,height: 105mm
After Folded (without props): length: 510mm,wide: 185mm,height: 105mm
After Folded (with props): 590mm,wide:185mm,height:105mm
Attachments
Last edited by a moderator: