Welcome To DroneVibes

DroneVibes is a COMMUNITY of drones enthusiasts. We are experts at drones for all professional and consumer applications. We welcome you to register and join the conversation.

About the TX of ESC chip of DJI spark

Discussion in 'Drone Electronics' started by dji_chao, Mar 4, 2019.

  1. dji_chao

    dji_chao New Member

    2
    0
    1
    Mar 4, 2019
    sg
    Posted by dji_chao, Mar 4, 2019 #1
    I am an electronics hobbyist.
    My intention is to drive TX of ESC chip myself. Currently I have a few hardware below
    1) DJI Spark Brushless Motor 1504s
    2) ESC Board for DJI Spark Part
    3) Some FPGA development board.​
    I can build hardware or build some MCU system to write some firmware code.
    I thought I can have a lot of fun by driving TX of ESC myself using my own hardware/firmware code, to test drone flying control.
    I can even build some prototype by integrating my own host system with the 4 DJI spark ESC+motor.
    So hope someone can share some typical TX commands/patterns required.
    Thanks!
     
Loading...

Share This Page

Loading...