JLO
Member
Hi im flying successfully a coax 8 copter with DJI A2 electronics i need advice on fine tuning the motor mixer the reason is that the bottom motors are warmer than the top motors making me to asume that the bottom motor is working harder or pulling more amps than the top motors
I have already try the following prop size combinations :
1 equal size prop on top and bottom
2 smaller prop on the bottom and larger on top
3 larger on the bottom smaller on top
I get the same the lower motor are warmer than the top
so decided to look at the mixer table in the DJI software but the table has only 0 in all the boxes, to compare the Mikrokopter mixer table has the digit 64 and -64 in some of the boxes and some users have use this to fine tune their mixer on a Coax setup has anyone ,made adjustments on their DJI mixer
take a look at this Wiki from DJI http://wiki.dji.com/en/index.php/Customize_Motor_Mixer
thanks.....anyone?
I have already try the following prop size combinations :
1 equal size prop on top and bottom
2 smaller prop on the bottom and larger on top
3 larger on the bottom smaller on top
I get the same the lower motor are warmer than the top
so decided to look at the mixer table in the DJI software but the table has only 0 in all the boxes, to compare the Mikrokopter mixer table has the digit 64 and -64 in some of the boxes and some users have use this to fine tune their mixer on a Coax setup has anyone ,made adjustments on their DJI mixer
take a look at this Wiki from DJI http://wiki.dji.com/en/index.php/Customize_Motor_Mixer
thanks.....anyone?