Bought DJI Flame 450,built the kit while out of town without my pc. A friend who had a 450 set up my model on his pc using my Futaba 8FGA. Model flew fine except for some toilet bowling effect which I thought that I would correct when I got home and went through the DJI assistant setup on my pc. Returned home to find that my DJI GPS unit had arrived. I installed the GPS unit and proceeded to try and set it up in the DJI assistant on my pc. First, I insured that the computer had MS framework software, turned on my transmitter, plugged in battery, then connected the usb cable from pc to VU, downloaded and saved the DJI installation driver using the zip file, ran the program, then downloaded and saved the DJI Assistant 1.8 software using the zip file, ran the DJI Assistant software and the program kept coming up MC OUTPUT ON obviously not allowing me to get into the setup to make any necessary changes. After numerous attempts of starting over and not getting a positive outcome I tried installing the 1.6 Assistant software but continued to have the same result. My thought was that if I was successful with the 1.6 software, there was probably an ability to upgrade to the 1.8 software to become current. At this point I am frustrated and don't know what to try next.
Any thoughts on what I am doing wrong or how I should proceed??
Thanks!
Any thoughts on what I am doing wrong or how I should proceed??
Thanks!
there is separate area to do so! Let me know how that works...