Search results

I don't use course lock because I only have one 3 way switch on my dx7. I have home lock and off on a 2 way switch. I thort home lock worked in a way that it would return craft to recorded home position so if you loose orientation of your multi you could flick the home lock switch pull the stick...

I don't have course lock setup only home lock. my dx7 only has one 3 way switch so that is set up to gps/att/man and one 2 way is set up for RTH/off and the other 2 way is Home lock/off

no I used home lock previous to trying RTH, when I tried home lock it worked perfectly. so I switched home lock off and flew away again and then tried RTH it did all the things it was meant to but as it came back to me it was going off course. (weird as home lock test was perfect) and it was...

yes it came directly back to me using home lock, that was a few minutes before I tried the RTH all in the same flight

yes it is definatly is set up correct in assistant ive checked post crash and is still correct. it ilso strange how it went off course by 10 meters or so aswell before going out of control and right before i did the rth i had dome a home lock return and it was bang on course to home point. im...

yes had the 16 green flashes and all red sattilite leds went out so had found all sattilites. on inspection at home ive discoverd one motor is burnt out now i dont know if it burnt out on impact as the prop did not break so unsure if it was cause of the crash. if a motor goes out in a hexcoptor...

I was in GPS mode with flashing green led with all satellites as there were no red leds. I activated RTH with the two way switch I had set up. the failsafe activated fine and the amber leds were flashing

Hi there im in NZ and have a tarot 680 hex setup with a naza V2 system with GPS. I have the arrow of compass set to face forward as per manual, I don't semm to get TBE but yesterday I did a RTH test, it was a little windy id say round 10knts. the RTH amber light flashed as per normal it...

ok I have TX set up in Acro mode and the gps/att/man set up on the flight mode switch (norm/st1/st2 switch) I have failsafe set via TX turning off only. I havnt got any switches set up yet for RTH which is what I want to do

so go to mix 1 and set it as AIL>Rud? but I see in the picture it say mix 1 is ax1>ax1. is that aux1>aux1?

any idea why now my aileron and elervator travel only goes from one side to the middle only, it was going from left to right

ok thanks, ive just set up failsafe via the link you gave me and its all working now, is it possible to set up a return to home via a mix to a switch?

so what if you want to flick a switch for return to home? do you have to turn your tx for it to return home?

I have the flight mode 3 way switch set to man/att/gps , but im stumped on setting the failsafe when tx is turned off or assigning failsafe to a switch

hii have a Dx7 with orange rx set to pre-set failsafe. ive seen some threads with heli setup and some with acro. can anyone give me the setup for a DX7 radio please?