Search results

In the past I have been using the DJI 30A ESC's and the DJI motors that come with the F450 ARTF kit but now that I am trying to custom build everything, I got tired of the DJI motors so I moved up to the T-Motor MT2212-13 980 kV motors. I hooked them up to my DJI 30A ESC and only one motors...

I just finished all of the soldering and connecting of wires on my new F450 with Naza M V2. I have a Devo 10 controller which I used on my old F450 with Naza M V1. When I first plug into Naza assistant, I get a CFG Error: "Configuration error, this may cause by firmware upgrade from old...

Took a hard crash with my DJI F450. Got two arms replaced and when I tried to fly again, it wouldn't get off the ground in GPS mode. Manual mode worked fine as usual. I noticed the GPS unit came unplugged so I then tried to recalibrate. Horizontal calibration went fine but when I tried to do the...

I replaced a DJI motor that was not spinning and when I went to start it up, the motor on the same arm started smoking and shaking! Would that be the ESC or is it another motor?

I have asked DJI but not got a response. My quad will start when I push both sticks down and left, down and right, and down and out. For some reason, when I move the sticks down and inward, nothing happens. Down and in was the keystroke I used when I first started, but a few days later, that...

Would love to hear if anyone has any good ideas to be able to tell the front from the rear on my quad. Have a Dji 450 with red in front and white in back but once it gets far enough away there is no way to tell orientation. Thanks!

Hi, I have Dji 450 with naza and GPS. I was trying the FailSafe and when I flipped the switch and it went on a straight angle to the ground and took a hard crash and the props continued to try to spin while it was upside down. It was ugly. Why would this have happened?? I had just calibrated...

I've got a DJI F450 and currently do not have the GPS connected. Still when I am in "GPS" mode, the quad is much more stable. ;It seems like there are angles set up that it cannot go past. When I flip to manual mode, it is a completely different machine where the slightest move of the right...