Search results

On my Jeti receiver in PPM mode, the receiver shuts off the signal (not 0%, but OFF) if connection to the transmitter is lost. The Naza goes into failsafe mode when the signal is shut off, but I have two questions regarding this: 1) I have read that the throttle signal should be 50% (at least...

Is it possible somehow to increase the flip/roll rate in manual mode on the Naza? It flips and rolls quite slowly. Given that it flips super fast back to upright hover when going from manual to atti, it should be physically possible.

Is anyone running 6S batteries on a F450-sized quad? What motors and ESCs are recommended? I'd like to share my 6S 3300 mAh packs with my helicopter.

Is it necessary to use black electrical tape on the sides of the Naza v2?

I have a DJI Naza on a TBS Discovery frame. Motors, ESCs and props are stock DJI. It flies very well. However, at take off it's very unstable and tends to fly forward. Last time I flew it was so bad it flew into a pile of snow, and I broke a prop. A couple of seconds after liftoff, however, it...

Does anyone know anything about these OSD units for DJI Naza? http://firebug24k.com/index.php The specs look promising (although I'm a bit skeptical to do soldering on the GPS), but I can't find any information or sample video images.

I have set my DJI Naza "Cut Off type" to "Intelligent mode". My understanding is that the motors will not stop even when setting throttle to 0%, unless i land or the quad for some reason tips over (more than 70 degrees angle). Is this correct? Furthermore, if I understand this setting...

I have a DJI Naza with TBS Discovery frame. When I fly fast forward in GPS ATTI mode, the quad sometimes get some strange hickups: It's super stable in hover. This only happens in fast forward or sideways flight. I'm using Graupner 10" props plus standard DJI motors and ESCs. Any theories on...

I'm having problems entering the GPS calibration mode. Sometimes it works, sometimes not. Does the control mode channel need to go between specific values? How fast should I flick the control mode switch?

1) The manual on the DJI Naza says that "You must re-configure if the ALL-UP-WEIGHT had been changed on your multi-rotor" under "Mounting location". I can't find any AUW setting in the software. Where do I define this? 2) Why does the software need to know about the location of the GPS relative...

I've seen that the Naza supports Futaba S-Bus. Does it also support Jeti R-Sat, or will I need to use a standard receiver with patch cables on a Jeti transmitter?

I have a Futaba 8FG radio which I consider using for a DJI Naza. Is there any reason to choose the R6208SB receiver over R6203SB? The Naza uses SBUS anyway, right?