Search results

Have you got it connected to the WKM? It dosen't work without a WKM.

Have you checked with the Zenmuse Assistant software that you have actually got the HDMI turned on? You might have to adjust the TX end point until the red bar appears.

they have the tutorial on Futaba, JR radio setup on youtube https://www.youtube.com/watch?v=_TypyVJRCxw https://www.youtube.com/watch?v=ZY4vqTga3w8

From what I understand DJI have approximately 300 employees, about 80-90 of which are in R&D. This is just for Multi-rotor and Helicopter. With this kind of resource the future should look interesting!! HobbyKing is "no" comparison.

The retractable legs come per-calibrated. The manual states to skip the calibration if the servos are pre-installed Why are you calibrating from new?

I think the Bluetooth module will link to their existing datalink, so 2-3km with 2.4ghz or 6-10km with 900mhz (900mhz not allowed in Europe). So, iPad Bluetooth to BT module, BT module connects to Datalink, Datalink 2.4ghz on multirotor about 2km.

I'm sure DJI are doing this through the App Store, and if I was them I would also charge for it. To get some of the development costs back. it normally takes a week or two for the product to actually appear after DJI release it. So let's see.

It is not the same as the AR Drone setup. Far from it.

Skall mistake on the video...there will be no manual mode!

Contact Martin here: http://www.buildyourowndrone.co.uk/aboutus.asp I think he's your closest "DJI Authorised" dealer. Explain your situation, he will probably try to help and he's a really nice guy.

Contact a DJI authorized dealer...see here: http://www.dji-innovations.com/produ...-s800/dealers/

You need to upgrade to 5.16 for the OSD to work

Where did you buy it? Contact a DJI authorized dealer...see here: http://www.dji-innovations.com/products/spreading-wings-s800/dealers/

DJI have released their promo video... http://www.youtube.com/watch?v=e1ZbJFme7VY&feature=player_embedded

???? what are you reading? I was 100% correct yesterday. Nothing has changed, DJI have just made it clearer for the individuals that didn't understand it :tennis:

Sandor..you owe me a large dunkel beer :tennis: The retractable landing gear comes with the servos already fitted. The servos are pre-programmed for end point adjustment, you can not do this via the TX (due to the clever control PCB). The retracts will ONLY be supplied with servos. The control...

The servo power is turned off 3 seconds after reaching the end position, so current draw isn't an issue. It has a clever controller fitted. The manual shows how to fit the servos incase you need to change one. We will check with DJI tomorrow, I bet you a beer :nevreness:

I think you could be wrong!!! I will check this tomorrow when they're in the office??? As I see it they come with the servos fitted + they offer the servos on their own as spares.

What are you going to do with all the servos you remove from the retracts? Because they are shipped per-assembled??